Use and Care Manual

8 9
IMPORTANT: Please observe all governing codes and ordinances. It is
recommended that a qualified technician install the range hood. It is the
installer's responsibility to comply with installation clearances specified
on the model / product rating label.
Range hood's location should be away from strong draft areas such as;
windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance.
LOCATION REQUIREMENTS
INSTALLATION DIMENSIONS
24”-36”
30.75”
to
42.25”
Minimum Drop -
Down Height: 30.75"
Ceiling Height: 8-9 Feet
VENTILATION REQUIREMENTS
A. Chimney hole
B. 6" (15.2 cm) round vent
A. Roof cap
B. 6" (15.2 cm) round vent
Part CFK1-TM is required (Sold Separately).
This range hood is factory set for through
the roof or wall.
Rear Venting
For Ductless (Recirculating)
Installations
chimney vent holes. See Page 16 for
ductless conversion instructions.