Owner Manual

B
Locate the 6" round aluminum duct (F) and
attach it to the top air outlet on the main body
of the range hood with HVAC foil tape
(not included). Make sure it is connected
tightly.
Place the bottom of Outer Chimney into Core
Body's seating located near vent hole.
Then Insert the Inner Chimney cover into the
Outer Chimney Cover.
Note that the Inner Chimney cover must slide
into the Outer Chimney cover's orientation slot.
(see step 7 for mounting bracket install)
A
Use 3/8"
screws
(parts list C)
A
B
* (Step 7)
Using a pencil, place a small mark on the wall
on each side of the chimney
10
The drilled hole should be slightly smaller
than the diameter of the anchor.
Drill 1/4" holes at each marked location
Align Inner chimney bracket (H) with the
drilled holes and firmly screw it into place.
Align the middle of the Inner chimney
bracket (H) with the drawn line and make
a mark where each screw hole in your
wall will need to be drilled for mounting of
the bracket.