Use and Care Manual

30 31
INSTALLATION INSTRUCTIONS
3) Remove the retainer pin (see Figure 21).
4) Reverse the retainer pin and put back into the regulator cap. This is how the regulator pin looks
for LP gas usage (see Figure 22).
Figure 21
Figure 22
5) Screw the regulator cap back into the regulator and re-attach the regulator to the nipple and flare
union (see Figures 14 and 23).
Figure 23
INSTALLATION INSTRUCTIONS
B. CHANGE BURNER NOZZLES
INSTALLATION TIP: First remove all nozzles and then start replacing them. This will help to prevent
the possibility that some may not be replaced.
1) Remove the burner grates, burner caps and burner heads.
2) Using a 7mm nut driver, remove the burner nozzles.
IMPORTANT: Carefully read and observe each nozzle label for correct location (see Figure 18).
3) Install the proper nozzles in the exact locations as noted in the illustrations above (see Figure
24).
4) Replace the burner bases, heads, caps and top grates. Make sure burner caps are properly
seated on the burner head (see Figure 17).
Figure 24
TRIPLE RING BURNER
5 NOZZLES
AUXILARY BURNER
SEMI-RAPID BURNER
RAPID BURNER
1 NOZZLE EACH
NOZZLES