Use and Care Manual

26 27
INSTALLATION INSTRUCTIONS
Electrical Connection
Before making the connection, make sure that:
1) The safety circuit-breaker and the electrical system are able to with stand the load of the
appliance.
2) The power supply system has a ground connection in good working order in accordance with the
regulations in force.
3) The electrical socket is easily accessible with the appliance installed. In all cases, the power
supply lead must be positioned so that it does not reach a temperature 50
o
C above the room
temperature at any point.
4) If installed above a built-in oven, the cooktop cable must not touch the oven below (see Figure 15).
Figure 15
INSTALLATION INSTRUCTIONS
Assembling the Burners
The electrode of the electronic ignition system is positioned above the surface of the burner base. Do
not remove a burner cap or touch the electrode of a burner while another is turned on. Damage or
electrical shock may occur.
1. Place burner heads over the burner base. Make sure the hole in the burner head is properly
aligned with the electrode in the burner base (see Figure 16).
2. Place the burner caps on the burner heads. Make sure that the burner caps are properly seated
on the burner head (see Figure 17).
Figure 16
3. Operation of the electric igniters should be tested after the cooktop and supply line have been
carefully checked for leaks and the cooktop has been connected to the electrical power. To check
igniters, push and turn a burner valve to the LITE position. All spark igniters will make a series of
sparks (ticking sounds), but only the burner turned to LITE will light.
Figure 17