Installation Guide

Step 5:
Sllide the inner and outer chimney covers
over the blower assembly box. Then pull
the duct up to the level of the inner
chimney cover.
Step 6:
Per the screw postions on the ceiling
mount, drill (4)8 mm holes into the
corresponding locations on the ceiling.
Then insert the provided anchors into
each hole. Next, affix the ceiling mount to
the ceiling by screwing it in, according to
the drilled holes with anchors.
8
Step 4:
Step 7:
Connect the rest of the assembled unit to
the ceiling mount using 10 pcs of the
provided screws.
Determine desired height of hood.
Based on your measurements, connect
upper support frame to lower support frame
using 16 screws and nuts.
16 pcs nuts
16 pcs screws
Inner Chimney Cover
Outer Chimney Cover
Ceiling Mount
Blower Assembly
197
Ceiling Mount
Ceiling Mount
Rubber Anchors
10 pcs screws
Screws