Use and Care Manual

CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR

PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY

PARTS FOR INSTALLING, CLEANING OR SERVICING.

INSTALLATION PROCEDURES

Wall Mount Installation Method

For Ducted Installation

A. Find the 4 mounting holes in the back of the range hood. Mark their locations at the

installation location with a pencil or marker.

Drill 5/16 (8mm) holes

at each of the marked locations.

C. Insert anchors along with screws into each drilled hole. Firmly tighten the screw into

place. Do not tighten the screws all the way. Leave the screw heads about 1/4 in. out.

D. Drill a hole either in the wall or cabinet large enough to wire the electrical supply for the

unit.

E. To duct through the wall, cut a 9.8" x 3.23" hole into the wall and install the metal cover

over the top vent hole. To duct through a cabinet above the hood, cut a 9.8" x 3.23"

rectangle into the bottom of the cabinet and install the metal cover at the rear vent hole.

F. Hang your Range Hood into place by aligning the screws with the 4 mounting holes in

the back of the range hood. Lock into place by sliding down the range hood.

For Ductless Installation

Drill only the four 3.5mm diameter holes as pictured below.

1.Make sure the metal cover is installed to the rear vent, since the recirculated air will go

through the top. If there is a cabinet above the range hood, cut 9.8" x 3.23” hole into the

bottom of the cabinet.

2.Align the damper inside the cabinet with the hole just cut. Install the damper inside the

cabinet with screws.