Use and Care Manual

CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR

PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY

PARTS FOR INSTALLING, CLEANING OR SERVICING.

INSTALLATIO N PROCEDURES

Cabinet Installation Method

For Ducted installation cut a 9.8" x 3.23" rectangle into the cabinet. (this will be for the

ductwork) and four 3.5mm diameter holes as pictured below picture. 1.Make sure the

metal cover is installed on the vent hole that will not be venting the air. Put four wall

anchors into the drilled holes. Screw the four self tapping screws into the wall anchors.

Do not tighten the screws all the way. Leave the screw heads about 1/4 in. out.

For Ductless installation do not cut into the cabinet or wall. Drill only the four

3.5mm diameter holes as pictured below.

A. Remove the metal cover from the back of the unit.

B. Leave a 1/4" space from the wall to the back of the unit. This space will be needed to

recirculate the air.

C. Drill a hole either in the wall or cabinet large enough to wire the electrical supply for

the unit.

Use the 4 screws to mount the

Range Hood to the cabinet. Check

that your mounting screws are in the

correct place by lifting and fitting the

Range Hood in place. At the same

time, feed the power cable and

electrical wires through the opening

for the power access. If correct, lock

into position by pushing in the

Range Hood.