Installation Manual

3 Dra

w a horizontal line at the height of the front of your cabinet. This is where the top of your template will

be. If the bottom of your cabinet is flat, make sure that you leave space for the power cord.

4 T

rim the rear wall template along the dotted line.

Step 2: Align the rear w

all template

If the rear wall template is damaged or unusable, see “Rear wall template

dimensions” on page 40 for dimensions.

Notes

• If installing the microwave beneath smooth, flat cabinets, make sure that you

leave enough space for the power cord clearance.

• If cabinets have decorative trim that interferes with the microwave installation,

remove the trim to install the microwave properly and to make sure that it is level.

Rear wall t

emplate

Power cord

Cabinet

Flat bottom:

Front overhang:

Recessed back:

NOTE:

1 Use a level to make sure that the b

ottom of the cabinet is level.

2 Draw a vertical line down the center of the wall in the mounting space.

This is where the center of your template will be.

5 T

ape the template in place so that it is centered on the vertical line and

the top edge is aligned with the horizontal line.

Vertical line in the center

Top of the template aligned

with the horizontal line

6 F

ind a hole that aligns with a stud (this is C or D).

CAUTION

You must mount to at least one stud.

7 Dri

ll holes through the template at points A, B, and C or D. If the hole lines up

with a stud, drill a 3/16” hole. Otherwise, drill a 5/8" hole for the toggle bolts. You

must use at least three holes for mounting.

Note: Depending on your stud locations, your installation may look

different. You should mount to at least one stud.