Installation Manual

10 11

Removing y

our micro

wave

1 Remove the documentation, filters, glass tray, and hardware bag from

the box. Do not remove the Styrofoam protecting the front of your mi-

crowave.

2 Fold back all four box flaps, then carefully roll the microwave and box

over onto the top side. The microwave should be resting in the Styro-

foam.

3 Pull the box up and off the microwave.

4 Remove and throw away the plastic bags.

Styrofoam

Box

Installing your microwave

Step 1: Find the wall studs

1 Using an edge-to-edge stud finder, locate the edges of the

wall stud(s) within the opening.

2 Mark the center of each stud, and then draw a vertical line

down the center of each stud.

Warning

our microwave must be connected to at least one wall stud.

The center of any adjacent wall studs should be 16" or 24

" from this mark.

Wall

stud

Center of the

wall stud

Warning

You’ll need:

Edge-to-edge stud finder

Ruler or tape measure Pencil