Installation Manual

66 in. (167.6 cm) or more
from the floor to the top of
the microwave
16-1/2 in.
(41.9 cm)
3
0
i
n
.
(
7
6
.
2
c
m
)
30 in.
(76.2 cm)
2 in. (5.1 cm)
6
7
TOOLS YOU WILL NEED
# 1 Phillips screwdriver
Pencil
Ruler or tape measure and
straight edge
Carpenter square
(optional)
Tin snips (for cutting
damper, if required)
Electric drill with
3
⁄
16
“,
1
⁄
2
“ and
5
⁄
8
“
drill bits
Hammer (optional)
Stud finder or
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed bottom
cabinet installations only)
Gloves
Saw (saber, hole or keyhole)
Level
Duct and masking tape
Scissors
(to cut template, if necessary)
Safety goggles
Mounting requirements
• The space between the cabinets must be 30 in. (76.2 cm) wide. If the space between
the cabinets is more than 30 in. (76.2 cm), you’ll need filler material to fill the gap
between the microwave and cabinets.
• This microwave is for installation over ranges up to 36 in. (91.4 cm) wide.
•
If installing the microwave beneath smooth, flat cabinets, make sure that you leave
enough space for the power cord clearance.
• If you are going to vent your exhaust to the outside, see “Exhaust requirements” on
page 8 for exhaust duct preparation.