Installation Manual

38
39
Step 6: Option C - Mount the microwave
CAUTION
For easier installation and personal safety, we recommend that two people install
this microwave oven.
Do not grip or use the handle during installation.
To keep the power cord tight while mounting the microwave oven, thread the
power cord through the hole in bottom of the top cabinet.
1 If your cabinet is meta
l, insert the nylon grommet into the power cord hole to prevent
cutting the cord.
2 Lift the microwave, tilt it forward, and hook the slots on the back bottom edge onto the
four lower tabs of the mounting plate. Rotate the front of the microwave up against the bot-
tom of the cabinet.
Note
We recomend using filler blocks if the front of the cabinet hangs below the
cabinet’s bottom shelf.
If filler blocks are not used, damage may occur from over-tightening the screws.
Thread the power cord through the cable
hole in the top cabinet. Keep it tight
throughout steps 1-2.
3 T
o temporarily hold the microwave in place, insert a self-aligning machine screw
through the top-center cabinet hole and rotate the screw at least two full turns (it
will be fully tightened later).
CAUTION
Be sure to keep the power cord tight. Do not pinch the cord, especially when
mounting flush to the bottom of the cabinet.
Front of cabinet
Bottom of cabinet
Filler block (optional)
Self-aligning machine screw
Top of microwave
Equivalent to depth of cabinet recess
4 T
o attach the microwave oven to the top cabinet, insert two self-aligning ma-
chine screws through the holes you drilled in the bottom of the cabinet. Turn each
screw at least two full turns (they will be fully tightened later).
5 While holdin
g the microwave up against the wall and cabinet, fully tighten
the top-center machine screw, then fully tighten the outer two screws.
6 F
it the two grease filters into the openings underneath your microwave.
7 You’re finished! Skip to “Before using your microwave” on page 40.
BOTTOM
You’ll need:
Nylon grommet
(for metal cabinets)
Self-aligning machine
screws
Grease filters
Phillips screwdrivers