Installation Manual

Step 4: Option C - Attach the mounting plate to the wall

Note: Depending on

your stud locations, your

installation may look

different. You should

insert toggle bolts into

drywall and wood screws

into studs.

1 Remove the rear wall template.

2 Remove the mounting plate from the back

of your microwave using a Phillips screwdriver.

3 Insert the toggle bolt(s) through the front of the mounting plate into the hole(s) that are not going into a stud,

and then attach the toggle wings ¾" onto each bolt. Hold your mounting plate up to holes in your wall to

identify the correct position.

Note

The top of the mounting plate is indicated with an arrow. The mounting plate’s

hooks are on the front.

Bolt

Wing

Mounting plate

4 Place the mounting plate

against the wall and insert the toggle wings into the holes

you drilled in the drywall. Pull the mounting plate away from the wall to help tighten

the toggle wings.

5 Insert wood screw(s) through the mounting plate and into the hole(s) drilled in the stud(s), then tighten both the

wood screw(s) and toggle bolt(s) with a Phillips screwdriver to mount the plate. Make sure that the plate is

centered before tightening fully.

Caution

Be careful to avoid pinching your fingers between the back of the mounting plate

and the wall.

Mounting plate

Wall

Toggle wing

Toggle bolt

You’ll need:

Wood screws

Mounting plate (Qty. 1)

(ships attached to microwave)

Phillips screwdrivers

Toggle bolts