Installation Manual

Step 4: Option B - Cutting a vent opening

1 Use a saber or keyhole saw to cut out the shaded area through the rear wall.

2 Remove the rear wall template.

Saw

You’ll need:

Saw

(saber, hole, or keyhole)

1 Remove the rear wall template.

2 Remove the mount

ing plate from the back of your microwave using a Phillips screwdriver.

3 Ins

ert the toggle bolt(s) through the front of the mounting plate into the hole(s) that

are not going into a stud, and then attach the toggle wings ¾" onto each bolt. Hold

your mounting plate up to holes in your wall to identify the correct position.

4 Place the mounting plate against the wall and insert the toggle wings into the

holes you drilled in the drywall. Pull the mounting plate away from the wall to

help tighten the toggle wings.

Note

The top of the mounting

plate is indicated with an ar-

row. The mounting plate’s hooks are on the front.

Note: Depending on

your stu

d locations,

your installation may

look different. You

should insert toggle

bolts into drywall and

wood screws into studs.

Bolt

Mounting plate

Wing

Step 5: Option B - A

ttach the mounting plate to the wall