Installation Manual

22
23
5 While holding t
he microwave up against the wall and cabinet, fully tighten
the top-center machine screw, then fully tighten the outer two screws.
6 F
it the two grease filters into the openings underneath
your microwave.
BOTTOM
You’ll need:
Nylon grommet
(for metal cabinets)
Self-aligning machine
screws
Grease filters
Phillips screwdrivers
Step 8: Option A - Connecting ductwork
1 Open the cabinet and slide the exhaust adapter front-to-back or side-to-side to adjust.
2 Extend the house duct down to connect to the exhaust adapter.
3 Seal the exhaust duct joints with duct tape.
4 You’re finished! Skip to “Before using your microwave” on page 40.
Blower plate
Exhuast adapter
Damper
Back of microwave
House duct
You’ll need:
Duct tape