Installation Manual

20
21
4 Place the blower unit back into the open
ing. The blower unit exhaust
openings should face upwards.
5 Slide the ex
haust adapter into the guides on the top of the microwave
until it is in the locking tabs.
F
an blade openings
facing upwards
Step 7: Option A - Mount the microwave
CAUTION
• For easier installation and personal safety, we recommend that two people install this
microwave oven.
• Do not grip or use the handle during installation.
• To keep the power cord tight while mounting the microwave oven, thread the
power cord through the hole in the bottom of the cabinet.
1 If
your cabinet is metal, insert the nylon grommet into the power cord hole to prevent
cutting the cord.
2 Lift the microwave, tilt it forward, and hook the slots on the back bottom edge onto the
four lower tabs of the mounting plate. Rotate the front of the microwave up against the bot-
tom of the cabinet.
Note
•
We recommend using filler blocks if the front of the cabinet hangs below the cabinet’s
bottom shelf.
• If filler blocks are not used, damage may occur from over-tightening the screws.
Thread the power cord through the cable
hole in the top cabinet. Keep it tight
throughout steps 1-2.
3 T
o temporarily hold the microwave in place, insert a self-aligning machine
screw through the top-center cabinet hole and rotate the screw at least
two full turns (it will be fully tightened later).
CAUTION
Be sure to keep the power cord tight. Do not pinch the cord, especially when
mounting flush to the bottom of the cabinet.
Front of cabinet
Bottom of cabinet
Filler block (optional)
Self-aligning machine screw
Top of microwave
Equivalent to depth of cabinet recess
4 T
o attach the microwave oven to
the top cabinet, insert two self-aligning
machine screws through the holes you
drilled in the bottom of the cabinet.
Turn each screw at least two full turns
(they will be fully tightened later).
Exhaust adapter
Locking tab
Guides
6 Secure the blower unit in
the microwave with five of
the screws you previously removed.
Note
Mak
e sure that the damper hinge is at
the top and that it can swing freely.
Exhaust adapter
Blower motor screw
Damper
Blower plate
Blower plate and adapter
screw
Blower plate and adapter
screws
You’ll need:
Phillips screwdrivers
Tin snips