Use and Care Manual

OPERATING INSTRUCTIONS
17
Microwave Drawer Locks
These instructions only apply to drawer type microwaves with protective lock when transporting. The lock is
used to prevent damage to the microwave due to drawer being opened when being transported.
Description of lock state:
Control panel
Plated lock
Facade (drawer)
State A State B
State A -> State B: As shown on the left, rotate the right lock forward 90° to the locking state.
State B -> State A: As shown on the right, rotate the right lock 90° to both sides to the locking state.
NOTES
1.) Before using the microwave, you must check whether the lock is in state A.
2.) Before transporting or if the microwave will not be in use for a long time, the lock must be set to state B.
3.) To switch the lock between state A and state B, rotate the lock to self-locking position.
4.) To avoid damage to the microwave caused by misuse, do not rotate the lock while using the microwave.
Description of using the lock:
State B
State A
State B
State A
The figure above shows the overall appearance of the drawer type microwave and the lock.
The lock can be in two positions, which are state A and state B. State A is used when the microwave is in
normal use, and state B is used when the microwave is being transported and not in use.
(COS-12MWDSS SHOWN ABOVE)