Use and Care Guide

1
.
7
7
"
2
2
.
0
4
"
IMPORTANT:
Installation must be in compliance with all local codes and regulations.
In order to ensure adequate ventilation, the back panel of the cabinet unit must be
removed. Installing the oven so that it rests on two strips of wood is preferable. If the
oven rests on a continuous, flat surface, there must be an cutout of at least 1 ¾” x 22”.
(See Figure 2)
The panels of the adjacent cabinets must be made of heat-resistant material.
In particular, cabinets with a veneer exterior must be assembled with glues which can
withstand temperatures of up to 215°F.
In compliance with current safety standards, contact with the electrical parts of the oven
must not be possible once it has been installed.
To fasten the oven to the cabinet, open the door of the oven and attach it by inserting
the 4 wooden screws into the 4 holes located on the perimeter of the frame.
Figure 2
1
1
1
9