User Manual

9 10
5. Attach Harness
Strap Loops to
Splitter Plate
Sewn ends of the
harness strap loops
MUST face towards
you.
DO NOT twist harness strap or harness
adjustment strap. Make sure the harness
strap loops are fitted COMPLETELY ON
both sides of the splitter plate.
sewn
end
WARNINGS: Make sure the
harness height is correct for your
child’s size.
Do not use this child
restraint rear facing
unless the top of your
child’s head is at least
1 in. (2.5 cm) below
the top of the child
restraint.
Do not use this child
restraint forward facing
if the tops of your
child’s ears are above
the top of the child
restraint.
Failure to follow these steps can
result in serious injury or death.
4. Rethread
Harness Strap into
Correct Shoulder
Harness Slots For
Your Child
See pages 4-5 for
fit guidelines.
When using the lowest shoulder harness slots, you MUST make these
adjustments.
2. With Buckle in
the 1st Slot As
Shown, Turn the
Seat Over
If you need to move
the buckle to the 1st
slot, see page 6.
3. From Bottom of
Seat, Pull Metal
Retainer Towards
You and Push It
Up into Middle
Slot As Shown
4. From Top of
Seat, Lay the Metal
Retainer Flat
Against the Shell
As Shown
Harness System Adjustments for Smaller Infants
continued on next page
1. Pull Up Front of
Seat Pad