Installation Manual

45
46
F. Installing Forward-Facing
Check LATCH Belt
Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the
child restraint from side to
side, forward and back. The
child restraint should not
move more than 1 inch.
NOTE: If it moves more than
an 1 inch, try reinstalling the
child restraint or try another
seating location.
Secure your child in the
child restraint.
5.
To Remove LATCH Belt
From Vehicle Anchor
Remove child from child
restraint. Press down
firmly on adjuster side of
child restraint and press
release button to release
tension. Unhook LATCH
from bar by squeezing
spring lever and twist hook.
6.
F-5 Install Forward-Facing
With Vehicle Belts
Secure LATCH Belts
You MUST fasten the
LATCH belt hooks to the
side of plastic shells as
shown when using the
vehicle seat belts.
1.
Do not use the LATCH system along with the
vehicle belt. Secure LATCH belts when using
the vehicle belts.
Check the vehicle belt before each use. Use
only if the belt is tightened properly and
securely.
Failure to follow these warnings can result in
serious injury or death.
Note: Review the section D-4 to determine what kind of
vehicle belts you have. Review your vehicle’s owner manual for
vehicle seat belt use.
Place Child Restraint
in Vehicle
Forward-Facing
Place child restraint flush
against the vehicle seat
back forward-facing.
2.
continued on next page.
Meijer.com