User guide

Chapter 2
Reviewing
Some Basic Points
About Your
System
Your Corvus hard disk system should be installed and configure
at this
pOint, following the ·directions provided in the installatio
guide for your computer. The standard configuration makes th
Corvus 6 MB and
10 MB~·drives appear as two extra-large flopp
drives to your compu'ter system (Drives C and D) and a Corvus 20 MI
drive appear as three extra-large floppies (C, D and E). These pseud
floppies
are called virtual drives. The entire Corvus disk is called
physical
drive. If your system only has a single floppy diskette drivE
you should have this single physical drive appear as two virtual drive
(for example, the TRS-80 Model" has a program called ONEDRIVI
to do this).
Start-Up of Your Computer System
Insert the CP/M boot diskette into Drive A:. The screen display
the initial
boot instructions and information on the CP/M versiol
(you should have version 2.2
or later), and then a prompt, similar to
CP/M VER. 2.2 COPYRIGHT DIGITAL RESEARCH
CORP.
A> _
Insert a CORVUS UTILITIES VOL. 1 diskette into Drive B:.
Type B: and press
< RETURN >. The screen displays:
3