User guide

ManualsBrandsCorvus systems ManualsComputer equipmentTRS-80 II

33

code program from directoll

(see Step

13

above). Afte

updating

controller code,

tun

format switch

off

(to the left)

.

See

Section 6

of

this manua

for examples of this operation

Toggle Reset

Switch. If drivl

does not become ready afte

1

to

2 minutes, the final

steJ

is to reformat the drive

(SteJ

#15).

13.

First, read the section

or

,reformatting the Corvus drivi

(refer to Section 6

of

thi:

User Guide).

WARNING

REFORMATTING

THE

DRIVE WILL DESTROY

All

DATA

ON DRIVE. BACK

UP

DATA

IF

AT

ALL POS-

SIBLE.

COpy

DOWN

SPARE

TRACK TABLE AND

VIRTUAL DRIVE OFFSET

TABLE

AS

WELL.

Power the Corvus drive down

Flip the Format

Switch (sec

ond switch from right) to

thl

right. Power drive up.

Run

CDIAGNOS progran

from floppy drive.

Select op

tion

#6.

Type the contro"e

code

(CORVXX. XXX) witt

an

.FMT extension, example

CORVB173.FMT

Answer the questions

as

the~

appear on the screen.

ThE

busy light

wi"

flicker

rapidl~

for about one minute an(