User guide

B. FAULT AND BUSY
LIGHTS COME ON
AFTER
POWER UP SEQUENCE.
BUSY LIGHT FLASHES
FOR A WHILE, THEN
BOTH LIGHTS STAY ON.
32
7. Toggle Reset Switch on front
panel.
8. Check all front panel switches
for proper position.
9. Check flat interface cable con-
nections.
10. Unplug processor flat cable
and video connections (if you
are using the Mirror). Toggle
Reset Switch.
If drive becomes
ready, reconnect interface
cable (and video connections
if using Mirror), and repeat
the installation sequence,
making sure
cqrrect software
programs are used.
(See the
Installation Guide for your
computer for instructions).
11. If drive does not become
ready after
Step 10, turn for-
mat switch on and reset drive.
If the drive becomes ready,
refer to Section 6
of this User
Guide. Go
to Step 12.
If your drive still does not
become ready,
call your Cor-
vus Service Center.
12.
You will now update the con-
troller code on the drive (refer
to Section 6 of this User
Guide). Power drive down.
Turn format switch to the
right before proceeding.
Power drive up. Run the
CDIAGNOS program from
the floppy drive.
Select .op-
tion
#6. Update with controller