User guide

Chapter 5
Troubleshooting Your Corvus Drive
The Corvus disk system is designed to provide years of problem·
free use. At times, however, it may experience a hardware or software
problem. If your drive is not performing properly, consult the follow·
ing table for recommended actions.
Corvus Systems suggests that you take two
simple steps when YOL
first set up your system:
• Make copies of the Corvus Utilities Program diskettes.
• Copy down on paper the spared track and virtual drive offse1
tables. See page 00 of this manual.
PROBLEM OPERATION TO FIX PROBLE~
A. NO FRONT PANEL 1. Make sure power switch isor
INDICATOR LIGHTS .ON.
31
2. Check power cord connec
. tions
to drive and wall socket
3. Inspect fuse- replace witt
proper fuse
if blown (see thE
Installation Guide for you
computer).
4. Check the Voltage Circui
Board for correct
voltage anc
installation (see the I nstalla-
tion Guide foryourcomputer)
5. Listen to the drive and heal
if fan is spinning. If fan is no
operating, repeat Steps 1-4
then call your Corvus ServicE
Center for further instructions
If fan operating, go Step 7.
6. Toggle Reset Switch (right·
most switch on front panel)
If front panel lights remain of
(and fan is operating), cal
your Corvus Service Centel
for further instructions.