Instruction manual
8. Insert
the
Corvus interface card into
any
available
peripheral
slot
in
the
TRS-80
Model
II
card
cage.
Component
side of
the
card
should
face same direction as
the
other
cards.
9.
Connect
the
free
end
of
the
flat cable
to
the
interface card.
The
stripe
should
be
on
the
bottom
when
the
card is
in
the
card
cage.
10.
Carefully slide
the
top
of
the
computer
back
on
and
replace
the
screws.
11.
Tum
on
the
computer.
12.
Connect
the
AC
power
cord
to
the
disk
unit
and
to a
power
receptacle.
Tum
on
the
drive.
After approximately
40 seconds,
the
READY light
should
be
on,
the
BUSY
and
FAULT lights
should
be
off,
indicating
that
the
disk system is ready.
The
power
switch is located
in
the
lower
right
hand
comer
of
the
back panel.
If
the
disk system
does
not
become
ready
after
one
minute,
then
flip
the
RESET switch,
which
is
the
rightmost
switch
on
the
front of
the
drive cabinet.
13.
If
the
drive
is
not
ready
after
you
have
flipped
the
RESET
switch,
see
the
"Troubleshooting" section of
the
CORVUS
SYSTEMS' USER GUIDE FOR
CP
1M COMPUTERS.
10