Installation guide

7.
Plug a tap cable into the
tap box for the OmniDrive.
Remove the convenience connector from the
OmniDrive's tap cable. Plug the tap cable into
a tap box.
Plugging a Tap Cable
into the Tap Box
The OmniDrive is now installed on the network.
EXTENDING THE OMNINET CABLE
1.
This section tells how to extend the
OMNINET cable. Follow these steps only if
the OrnniDrive is farther than 15 feet (4.5 m)
from the cable.
Cut the
OMNINET cable.
Find the point on the OMNINET cable which
is closest to the OmniDrive. Cut the cable at
this point
23