Installation guide

ManualsBrandsCorvus systems ManualsComputer equipmentPersonal Workstation

CONNECTING

THE

DRIVE

TO

THE

NETWORK

1.

2.

It

is very easy to connect

an

OmniDrive to a

network. First

make

a network tap box,

and

then

plug the OmniDrive's tap cable into the

tap box.

Measure

the

distance

from

the

computer

to

the

OMNINET cable.

If

the OmniDrive

is

farther

than

15

feet

(4.5

m) from the OMNINET cable, extend the

OMNINET cable to the OmniDrive.

Go

to the

section,

"Extending

the

OMNINET

Cable."

If

the OmniDrive

is

within

15

feet

of

the

OMNINET cable, go to step

2.

Remove

insulation

from

the

OMNINET cable.

Find the point

on

the OMNINET cable

which

is

closest to the OmniDrive. Use a knife to cut

through the outer insulation

of

the cable.

Remove about 2 inches

(5

cm)

of

this

insulation,

but

do

not

cut the

inner

wires or

remove their insulation.

If

the

wires are cut,

splice the two halves

of

the OMNINET cable

using

step~

5 through 8

of

the section

"Extending

the

OMNINET

Cable."

OMNINET

Cable

Without

Insulation

20