User Manual

STEP ONE
Connect the AC/DC adaptor to the DC Inlet, found on the rear of the unit.
Fasten the Security Clamp (found directly below the DC Inlet jack) on top of
the cable, so that it is not possible for the cable to become dislodged.
STEP TWO
Connect either the XLR type (Balanced) audio output and/or the RCA type
(Unbalanced) Audio Outputs to a suitable audio mixer. When connecting
the unit, make sure you note that the either output will have the same music
program and both can work at the same time.
STEP THREE
Connect your primary USB device to the port found to the right of the rear
panel. You may choose any driverless device that follows FAT32, NTFS, or
HFS+ file systems. You may also connect a powered (active) USB hub to
augment the amount of available ports. If required, you may also connect
a device to the front USB port.
STEP FOUR
Press the Power button located to the left of the front panel. The unit will
take about 5 seconds to boot up as well as detect any USB devices that
are currently connected.
Using the HDC-500
Preparing for Use
Fig 1.1 - Connect Power
Fig 1.2 - Connect Audio
Fig 1.3 - Connect USB
Fig 1.4 - Turn Power ON
10