Telephone Accessories User Manual

8
3.2. Station Name Assignment
A name may be assigned to each 4-Line telephone unit. This name will display during Intercom calls.
Name assignment must be done from Station 01 and must be done with a 2740 or 2750 telephone.
To assign a name to a station:
a. Press
MENU
. The display will read “
Phone Setting
”
b. Press the soft key under
ENTER.
c. Press the
Down Arrow
repeatedly until the display reads “
Station Naming
”
d. Press the soft key under
ENTER.
The display will show the currently stored name for station
#01, or indicate “
No Name
” if no name has yet been given to station #01.
e. Press soft Key under
CHANGE
if you wish to store a new name for station #01, or press
DOWN ARROW
repeatedly until you see the station number that you want to name, and then
press the soft key under
CHANGE
.
f. Use the dial pad numbers to enter the name for the desired station.
g. Press the soft key under
SAVE
.
Repeat steps “a” through “g” for any additional stations you wish to name.
After assigning a Station Name at Station #01
,
it may take twenty four hours to update all
telephones
.
The table below shows the dial pad numbers to press for different letters and special characters.
Note
that you can press the 0, *, and # buttons if you want those characters, and you can press the
down arrow button below the display to leave an empty space. Press the
DELETE
button to make
corrections.
0 0
1 , - ' & . ( ) 1
2 A B C a b c 2
3 D E F d e f 3
4 G H I g h i 4
5 J K L j k l 5
6 M N O m n o 6
7 P Q R S p q r s 7
8 T U V t u v 8
9 W X Y w x y 9
* *
# #