Specifications

AddingPSTNLines
6. Theindividualportswillbe“created”anddisplayedinacolumnarformat.
● Virtualextensionnumber–IneffecttheVoIPGateway“converts”eachline/portto
anextension,sothatthephonesystemcanreceiveandforwardcallstoit.Thevirtual
extension number is a number assigned by the 3CX Phone System so that it can
addressitasanextension.Thereisnoneedtochangethisfield.
● AuthenticationID&Password – Thesevaluesareusedtoauthenticate the ports
with3CXphonesystem.
● Channels – The Channels field shows how many simultaneous calls the port
supports.Ananaloglinesupports1call;aBRIportsupports2calls,anE1(PRI)30,
and a T1 (PRI) 23. If you prefer to address each line individually, you can create
additional SIP accounts and change the number of channels supported by each
account to 1. Note that your VoIP Gateway must support this – especially higher
density VoIP Gateways are easier to configure if you use one account for all lines
connectedtoaport.
● PortIdentification–Thisfieldshowstheidentificationnumbergiventotheport.
● InboundRouteDay/Night –Iftheportwillreceiveinboundcalls,youcanspecifyto
whichextension,ringgroupordigitalreceptionistacallmustberouted.
7. On the next page, you can create an outbound rule for the VoIP Gateway that is being
configured. For example, you can have calls where the called number starts with a prefix
routedtothisGateway.Click“Finish”tocreatetheVoIPGateway.
Step2:ConfiguretheVoIPGatewayDevice
AfteryouhaveconfiguredthePSTNports,asummarypageisshown.TheconfigurationoftheVoIP
gatewaywillvarydependingonthebrandofthedevice.
BeroNetGateways
IfyouhaveaBeroNetgateway,youwillneedto:
1. Usethe“bfdetect”tooltofindthegatewayonthenetwork.
2. ConfiguretheGatewayin3CXasdescribedinthepreviousstep.
3. Clickonthe"configureBeroNetcard"buttonatthebottomofthesummarypage
4. Loginwithadmin/adminandfollowthescreeninstructionstocompletethesetup.
5. Moreinformationcanbefoundat:http://www.3cx.com/voipgateways/beronetberofix400
PattonSmartNodeGateways
IfyouareusingaPattonSmartNodegateway,youwillneedto:
1. UsethePattonSmartNodeDiscoveryTooltofindthegatewayonthenetwork.
2. ConfiguretheGatewayin3CXasdescribedinthepreviousstep.
3. Download the Patton configuration file from the summary page (or from the “VoIP/PSTN
Gateway”node>“GenerateConfigFile”button).
4. UploadtheconfigurationfiletothePattongatewaytoautomaticallyprovisionit.