Programming instructions

SLS FOR HEADSET: Cortelco Patriot
MEMORY LOCATIONS
Two-Touch and Single-Touch locations are used to store and retrieve numbers for
automatic dialing. Each location can store 15 digits, including number, flashes and
pauses.
To Store Numbers
Lift handset. (You will receive dial tone.)
Press the STORE button and dial the number -- 15 digits maximum. (If desired, press
the PAUSE button during dialing to insert a pause in the number sequence.)
Press the STORE button again
Press desired memory location button
Place the handset on hook or press the STORE button to continue storing numbers.
Use the shift button to store in two-touch memory locations.
To Dial Stored Numbers
To dial the stored numbers in the 10 two-touch memory locations:
1. Lift the handset.
2. Press the shift button.
3. Press memory location.
To dial the stored numbers in the 10 single-touch memory locations:
1. Lift the handset.
2. Press memory location button.
STORING AUTHORIZATION CODE FOR LONG DISTANCE DIALING
Note: The 15 digit limit does not allow an authorization code to be stored on the same
button as a long distance number.
However, a user could store an authorization code under one speed dial button and a
long distance number under another. Then to place the long distance call , the user
would do the following:
1 Lift the handset or press the HANDSFREE button
2. Press the speed dial button where the desired long distance number is stored.
3. Press the speed dial button where the authorization code is stored.