Instruction manual

12
3.7 Volume
The volume of the paging can be adjusted in two ways. First, the amplifier volume can be
adjusted, or the PAGING VOL control (Item 4 Page 7) of the 2743 may be adjusted. Adjustment
of the PAGING VOL control requires a small screwdriver. Turn the control clockwise to
increase the volume or counterclockwise to decrease. This adjustment will only work when the
amplifier is connected to the BLUE and BLACK terminals.
3.8 Paging
3.8.1 Multiple Units
Up to fifteen 2743 units may be connected to your system. Each must be connected to a separate
amplifier and speaker and each must have a unique station number.
3.8.2 Single Page
To make a page through a single 2743, simply press the PAGE button on your 4-Line Telephone
and dial the extension number of the 2743. Then speak into the handset of the telephone to make
your announcement.
3.8.3 All Page
All pages will be heard on every 4-Line phone in the system that is idle and is not set for DO
NOT DISTURB or PAGE BLOCK. In addition all pages will be heard over every external
paging adapter that is not set to block All Page (see Section 3.3.2).
To make an all page, press the PAGE button on your 4-Line Telephone twice. After the paging
tone is heard, speak into the handset of the telephone to make your announcement.
3.9 Troubleshooting
If you experience problems with your 2743, please check the items listed below.
1. Verify that the AC adapter is plugged into a working outlet. The outlet may be
verified by plugging a lamp or other device into it.
2. Verify that the AC adapter is plugged securely into the 2743. This may be verified by
checking that the 2743 status indicator is blinking.
3. Verify that the 2743 is plugged into the Line 1 wall jack.
4. Test the telephone wiring. Plug a standard telephone into the jack where the 2743 is
connected. Verify that you can make and receive a call. If not, the wiring is defective.
5. Verify that the DIP switch settings are correct. See Section 3.3 for the various DIP
switch settings.
6. Verify the connections from the amplifier to the wiring block and from the wiring
block to the 2743.
7. Verify that the speaker and amplifier are connected correctly and that the amplifier is
powered.