Instruction manual

7
Telephone Set Buttons
FLASH Button
Press the FLASH button to provide a line break to access services such as
Three-Way Calling, Call Waiting or VoiceManager features such as music on
hold and call transfer.
Steps to use with call waiting service:
1. While having a conversation, another party calls and you hear a tone.
2. Press FLASH once and release. The rst conversation is placed on hold and
the second call can be answered.
3. Press FLASH again and release. You may speak to the rst caller again and
the second call is placed on hold.
REDIAL Button
1. To redial one of the last 10 numbers dialed, press REDIAL. The display will
show the last number dialed. To scroll through the last 10 numbers, press
REVIEW UP or REVIEW DOWN.
2. After the desired number is selected, dial the number by pressing REDIAL
again, lifting the handset, pressing SPEAKER or pressing DIAL.
3. The selected number (32 digits maximum) will be redialed.
PAUSE Button
PAUSE allows you to insert a 3.6 second pause in the dialing sequence. This is
particularly useful if you are connected to a PABX system where you must dial
an access code (usually the number 9) to obtain an outside line.
1. Press PAUSE and release at any point in the dialing sequence where a pause
is desired.
2. PAUSE can be pressed more than once to create a longer pause.
HEADSET Button
This telephone will accept either a 2.5mm headset or an RJ-type headset
(Plantronics wireless or wired headset is recommended). Use HEADSET to
connect and disconnect from calls.