Other Content

Over on the "Power" tab, we see that the AX860i is only producing 107.3W as I sit here
watching the Link software. It's pulling 117.8W from the wall, so our efficiency is 91%.
On this tab, we can also monitor our voltages, including the voltage of our AC mains, as well as
current for each of our +12V outputs.
There are also check boxes that allow you to turn OCP on for the 8-pin +12V outputs (labeled
"PCIe") on the power supply. OCP stands for "over current protection" and will shut down the
power supply if too much current is delivered on any of these outputs.
Finally, we see the AX860i's temperature and the fan RPM on this tab. This is the same
information we saw on the "Graph" tab, but in a different format. The fan is still not spinning
because the temperatures are still low, but if we wanted to increase the airflow within our chassis
just a bit, we can manually turn the fan speed up.
We start on the "System" tab...