Owners manual

5/26/2017
INS616864
CORSA Performance·140 Blaze Industrial Pkwy·Berea, OH 44017 · P: [phone] ·F: [phone]
4
Metal Shield Air Intake System
2011+ Charger/Challenger 6.4L
PN 616864-O/D
E - M a i l : s a l e s @ C O R S A p e r f o r m a n c e . c o m · w w w . C O R S A p e r f o r m a n c e . c o m
18. Install silicone hump hose onto filter adapter. (Fig R)
19. Install silicone reducer onto duct. (Fig S)
20. Insert Corsa intake tube into silicone hump hose and over throttle body. Adjust duct as necessary and tighten hose
clamps. (Fig T)
21. Install filter onto filter adapter inside Corsa heat shield and tighten clamp. (Fig U)
22. Install supplied vacuum hose. (FIG V)
23. Plug in the air intake temperature harness. (FIG W)
24. Place Corsa Performance badge on heat shield or any other desired location. Attach CARB label underneath hood in
visible location.
25. Reattach the negative battery cable and recheck all connections before driving and retighten the clamps after 500
miles. (Fig X)
*Check that this air intake complies with your Federal, State and Local laws. We recommend saving your stock system.
BEFORE ROAD TESTING
1. Start engine, leaving the transmission in park and securing the parking brake.
2. Make sure to look and listen for any unusual noises or air leaks. Repair problems if needed.
3. Once completed it will be necessary to check periodically, after a few heat cycles, for realignment and
tightening of all connections.
CARE AND CLEANING
Check the Pro-5 cotton reusable filter periodically and remove any excessive dirt build-up by tapping the filter
on the ground and brushing off the loosened dirt. Clean the filter by using a two stage cleaning kit to
thoroughly clean and re-oil the filter. Re-oil every 10,000 miles without cleaning to improve filtering in sand
and dirt. Clean only when dirt is very excessive or 20,000 miles.
FOR REPLACEMENT FILTERS REFERENCE #5160/5161 & CALL 440-891-0999 OR TOLL FREE 1-800-486-0999
PICTURES ON NEXT PAGE