Owners manual

INS5401
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
11
10/1/2017
[e-mail] l www.corsaperformance.com
2015-2017 FORD MUSTANG GT 5.0L V8
Long Tube Headers: 1.875” Primary, 3.0” Collector
Part #: 16017, 16117
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
9. Plug the passenger side O2 sensor into the
extension installed during Install Step 2. Use the
supplied zip ties to secure the wires up and out
of the way of the headers to prevent melting. The
driver side extension will plug into the vehicle
harness near the oil pan. Connect the driver side
sensor and secure it within the spring clip on the
side of the transmission. Use zip ties if
necessary to prevent the wire from contacting
any exhaust components or coming loose and
possibly dragging on the ground.
10. Reinstall the factory engine mount brackets
using a ratchet and 13mm socket. Passenger
Side: Ensure the top bolt in the front has a
threaded stud on the hex end. Reinstall the
ground strap and secure with the 15mm nut
removed during Removal Step 17. Lower the
engine back onto the engine mounts.
11. Reinstall the starter, secure it with the three
10mm bolts from Removal Step 15 using a 1/4
drive ratchet and 10mm socket with 3” extension.
Connect the starter wires using the ratchet with
the 10mm and 13mm nuts.
12. Refer to the installation instructions included with
the CORSA X-Pipe (part number 14327), to
install the X-pipe onto the factory axle-back or
CORSA Cat-Back. Once the CORSA X-Pipe or
Cat-Back is installed, support the front of the X-
Pipe with a screw jack or similar device.
Continued on Next Page . . .