Owners manual

INS5403
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
9
10/1/2017
[e-mail] l www.corsaperformance.com
2011-2014 FORD MUSTANG GT 5.0L V8
Long Tube Headers: 1.875” Primary, 3.0” Collector
Part #: 16016, 16116
WARNING! DO NOT SKIP THIS STEP!
Apply the anti-seize lubricant (supplied) to the threads
ONLY of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly calibrated
Torque Wrench. Using an air impact gun will damage the
clamp and reduce its ability to effectively seal the joint. It
may also cause the joint to separate, thereby causing
damage to your exhaust system and to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
WARNING: CORSA Performance Headers are intended for off-road use only. Products are not
legal for sale or use in the state of California, or in states that adopt California Air Resources Board
emission standards.
NOTE: This instruction sheet assumes that the CORSA Performance X-Pipe (CORSA Part #
14370 or 14421) and CORSA Connection Pipes (CORSA Part # 16018) are installed in
conjunction with the CORSA long tube headers. May fit to other systems with modifications.
CORSA X-Pipe Part # 14318 DOES NOT directly bolt up to the CORSA Connection Pipes (Part #
16018), and will require modification.
CORSA’s warranty does not extend to damage or defect in the finish of a product or to any product
that in the opinion of CORSA Performance, has been misused, damaged by accident or
negligence, altered or modified in any way, faulty installation or installed contrary to CORSA
Performance installation instructions, or repaired by an unauthorized service facility. Full warranty
available on www.corsaperformance.com
NOTE: Individual vehicle variations and stock header differences can impact the order of
installation. The directions provided will assist in removal and CORSA installation. Please contact
a CORSA representative with any concerns.