Owners manual

INS5403
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
14
10/1/2017
[e-mail] l www.corsaperformance.com
2011-2014 FORD MUSTANG GT 5.0L V8
Long Tube Headers: 1.875” Primary, 3.0” Collector
Part #: 16016, 16116
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
21. Begin the final alignment process by snugging all
clamp bolts using a ratchet and 15mm socket.
The pipe overlap between all slip fit joints should
be slightly more than 1.5”. With the system
snugged, adjust pipe overlaps and check all
clearances to heat shields, wiring harnesses,
and chassis components.
22. The help of a second person is required for this
step. Ensure the exhaust tips are properly
centered within the rear bumper valence. Tighten
all clamps to 45ft-lb. Tighten the spherical flange
nuts and bolts to 15ft-lb or 180in-lb using a 1/2”
socket, extensions (as necessary), a torque
wrench, and 1/2” box wrench.
23. Perform one final check for exhaust system
clearances to any heat shields or chassis
components. Ensure no wires are contacting the
headers.
This concludes the work done under the
vehicle. Lower the vehicle to the ground.
24. Secure the top of the engine mounts with the
nuts removed during Removal Step 7, using
extensions, a ratchet, and a 15mm socket.
PRO TIP: “Wobble” extensions make this step
easier but a normal swivel section can be used.
Also, it is possible to do this from the bottom with
a “stubby” wrench.
Continued on Next Page . . .