Owners manual

INS5402
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
8
10/1/2017
techsupport@tmgperformance.com l www.corsaperformance.com
Long Tube Headers
1.875” Primary, 3.0” Collector
2014-18 Corvette C7/Z06
PN 16004, 16104
0
WARNING! DO NOT SKIP THIS STEP!
Apply the anti-seize lubricant (supplied) to the threads
ONLY of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly
calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively
seal the joint. It may also cause the joint to separate,
thereby causing damage to your exhaust system and to
your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
WARNING: CORSA Performance Headers are intended for off-road use only. Products are not legal for
sale or use in the state of California, or in states that adopt California Air Resources Board emission
standards.
NOTE: This instruction sheet assumes that the CORSA Performance X-Pipe (CORSA Part Number: 14761) is
installed in conjunction with the CORSA long tube headers. It is possible to install CORSA Headers with the
factory X-Pipe. May fit to other systems with modifications.
CORSA’s warranty does not extend to damage or defect in the finish of a product or to any product that in
the opinion of CORSA Performance®, has been misused, damaged by accident or negligence, altered or
modified in any way, faulty installation or installed contrary to CORSA Performance® installation
instructions, or repaired by an unauthorized service facility. Full warranty available on
www.corsaperformance.com
NOTE: Individual vehicle variations and stock header differences can impact the order of installation. The
directions provided will assist in removal and CORSA installation. Please contact a CORSA representative
with any concerns.