Owners manual

INS5356
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
8
03/19/2018
[e-mail] l www.corsaperformance.com
2009-2017 NISSAN GT-R
3.5” Cat-Back, Dual Rear Exit w/ Quad 5.0" Titanium Tips
Part #: 14999, 14999BLK, 14999BRZ (Tip Kit: 14998, 14998BLK, 14998BRZ)
WARNING! DO NOT SKIP THIS STEP!
Apply the anti-seize lubricant (supplied) to the threads
ONLY of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly calibrated
Torque Wrench. Using an air impact gun will damage the
clamp and reduce its ability to effectively seal the joint. It
may also cause the joint to separate, thereby causing
damage to your exhaust system and to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
1. Insert the CORSA axle pipe hanger into the
rubber hanger grommet from Removal Step 9
as shown.
2. Insert the CORSA rear muffler assembly hangers into the rubber hanger grommets from Removal Step
15 as shown.
3. Pre-assemble the provided 3.5” clamp onto the
inlet of the rear muffler assembly with the clamp
hardware on the top side of the muffler inlet, and
the nut facing towards the muffler case.
Continued on Next Page . . .