Owners manual

INS5356
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
5
03/19/2018
[e-mail] l www.corsaperformance.com
2009-2017 NISSAN GT-R
3.5” Cat-Back, Dual Rear Exit w/ Quad 5.0" Titanium Tips
Part #: 14999, 14999BLK, 14999BRZ (Tip Kit: 14998, 14998BLK, 14998BRZ)
REMOVAL INSTRUCTIONS
FACTORY EXHAUST
6. Remove the 4 nuts securing the left and right
mounting braces (2 per side) using a 12mm
socket and ratchet, and remove from vehicle.
7. Loosen the clamps on the stock tips using a
12mm socket and ratchet. Carefully remove each
of the four stock tips from the rear valence.
8. Remove the bolt on the center underbody panel
closest to the tunnel exhaust hanger using a
12mm socket and ratchet. Save bolt for Install
Step 8.
9. Remove the two nuts securing the tunnel exhaust hanger grommet to the chassis (save for Install Step
6) using a 12mm socket and ratchet. NOTE: The use of a soapy water solution may aid in the removal
and later installation of the hangers in the rubber isolators.
Remove the hanger grommet from the hanger using grommet pullers or similar device. Note the
orientation of the hanger grommet prior to removal and set aside the grommet and mounting hardware
for Install Step 1.
WARNING: Support the underside of the factory tunnel and rear mufflers using adjustable support
stands. The entire stock exhaust will droop down once the rear muffler hanger mounts are unbolted from
the chassis.
Continued on Next Page . . .