Owners manual

INS5356
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
10
03/19/2018
[e-mail] l www.corsaperformance.com
2009-2017 NISSAN GT-R
3.5” Cat-Back, Dual Rear Exit w/ Quad 5.0" Titanium Tips
Part #: 14999, 14999BLK, 14999BRZ (Tip Kit: 14998, 14998BLK, 14998BRZ)
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
8. Reinstall the bolt from Removal Step 8 on the
center underbody panel closest to the tunnel
exhaust hanger using a 12mm socket and
ratchet.
9. Slide a 3.0” clamp onto each of the CORSA F-
Pipe inlets so the clamp hardware sits forward in
the vehicle, and the nut is facing downwards.
Insert the F-Pipe inlet onto the muffler outlet with
at least 1.5” of overlap at the slip fit connection.
Adjust the position and rotation the F-Pipe until
the outlet pipes are centered in the factory rear
valence cutouts. Snug the clamp at the slip fit
connection using a 15mm socket and ratchet.
10. Hold the CORSA 5.0” tip with the logo facing up
and slide a provided 65mm clamp onto the inlet
so the hardware is to the inside of the vehicle,
and the nut is downwards.
Carefully install the tip onto the outer passenger
side F-Pipe outlet with at least 1.5” of overlap at
the slip fit connection. Adjust the position and
rotation of the tip to center the logo on top with
the desired amount of tip reveal.
Repeat for the second tip on the passenger side
and snug both tips using a 15mm socket and
ratchet.
Repeat for driver side.
11. Visually inspect the exhaust system position, tip
alignment, clamp orientation, and exhaust pipe
clearance. Make any necessary adjustments at
the slip joints and flange connections.
Start at the front of the vehicle and tighten all the
nuts and clamps. Torque all hardware nuts at the
three flange connections (downpipe and mid-
section) to 22 ft-lbs.
Torque the muffler inlet (3.5” clamp) and the F-
Pipe inlets (3.0” clamps) to 45 ft-lbs (61 N-m).
Hold the tips in the desired position and torque
clamps to 45 ft-lbs (61 N-m).
Continued on Next Page . . .