Owners manual

03/23/16
INS5316
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
7
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
Dual Rear Exit
2015 Dodge Charger & Challenger 6.4L V8
PN 14993, 14994, 14995(BLK), 14996(BLK)
Installation of CORSA Exhaust System:
NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure to
follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be
tightened using a properly calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively seal the joint. It may also
cause the joint to separate, thereby causing damage to your exhaust system and
to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the
notch in the pipe. (See Fig. CLAMP)
1. Remove all exhaust system components from the shipping boxes, including clamps and hardware.
2. Locate the x-pipe assembly and two 2.75” clamps. Install the clamps on the expanded inlet side of the x-pipe
assembly so that the bolts are horizontal with the nuts towards the outside of the vehicle, with the x-pipe cross
braces towards the bottom, slide the assembly over the stock exhaust pipes at the cat-back connection point.
(Fig. K) Position the x-pipe assembly so that it is parallel with the ground and centered in the tunnel cavity; snug
the clamps using a 15mm deep socket and ratchet. (Fig. L)
3. Next, locate the driver side tunnel muffler assembly and one 2.75” clamp. Install the clamp on the expanded
inlet side of the tunnel muffler assembly as shown in Fig. P. Slide the tunnel muffler assembly over the driver
side x-pipe outlet. (Fig. M) Position the brace so that it is parallel with the ground. After the driver side tunnel
muffler has been installed, located the passenger side tunnel muffler assembly and one 2.75” clamp. Install the
clamp on the expanded inlet side of the tunnel muffler assembly as shown in Fig. P. Slide the tunnel muffler
assembly over the passenger side x-pipe outlet with the brace parallel with the ground. (Fig. N)
NOTE: It’s important to install the driver side tunnel muffler assembly first as the brace is offset further forward
than on the passenger side to compensate for overlap.
NOTE: The driver and passenger side clamps will touch when not tightened. The clamps will pull in as they are
tightened creating adequate clearance. (Fig. P)
INSTALLATION INSTRUCTIONS CONTINUED ON NEXT PAGE