Owners manual

03/23/16
INS5316
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
10
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
Dual Rear Exit
2015 Dodge Charger & Challenger 6.4L V8
PN 14993, 14994, 14995(BLK), 14996(BLK)
13. Repeat step #12 for the driver side of the vehicle.
14. Connect both the passenger and driver side active valve modules. (Fig. KK)
15. Charger model ONLY
Locate the two chassis brackets and the hardware removed from step #1 of the stock exhaust removal process.
Re-install the plates using a 3/8” drive ratchet and 13mm socket (Fig. LL) Torque to factory recommended value.
16. Check that the clearance to the suspension mounts are adequate on both sides. Make sure that the x-pipe is
level and not rotated to one side, this will ease tip adjustment. Check clearance between the driver side axle
pipe and the spare tire well.
17. Adjust the system accordingly, including the rear muffler depth and rotation, so that the exhaust tip
outlets are centered in the bumper exhaust cutouts. (Fig. MM or NN) Check clearance between the
system components and chassis. Confirm the passenger side axle pipe does not interfere with the
heat insulated wires protruding from the spare tire well. At this time, tighten all clamps to 45ft-lbs
using the torque wrench and 15mm socket. This concludes the Corsa Performance exhaust
installation.
NOTE: Slightly loosening the rear muffler hanger assemblies from the vehicle chassis with allow side to
side adjustment of the tips. Hold the tip centered in the valance cut out while a helper tightens the
hanger grommet assemblies.
NOTE: During cold weather start-ups, you may experience an exhaust sound that is deeper and
louder in tone than usual. This is temporary and will diminish to normal levels once your engine
has reached its normal operating temperature.
NOTE: Immediately following the installation of your exhaust system, you may experience a trace
of smoke after initial start-up. DO NOT be alarmed. The smoke is caused by the burning of a small
amount of forming oil residue used in the manufacturing process.
INSTALLATION PICTURES ON NEXT PAGE