Owners manual

01/06/2017
INS5333
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
3
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
Dual Rear Exit
2015+ Dodge Challenger 5.7L V8
PN 14974, 14975, 14986/BLK, 14985/BLK
Factory Exhaust System Removal:
1. Using grommet pullers or a similar device, remove the driver and passenger side stock axle pipe hangers from
their corresponding hanger grommets. (Fig. A)
NOTE: The use of a soap and water solution may aid in the removal of hanger grommets.
2. Using a 3/8” ratchet and 13mm deep socket, remove the spring bolts at the driver side rear muffler flange
connection. (Fig. B) Next, using the ratchet, long extension, and 13mm socket, unbolt both the front and rear
driver side hanger grommet assemblies from the vehicle chassis. (Fig. C & D) The driver side muffler will no
longer be supported and can be removed by sliding it rearward until the flange clears the studs, then lowering
the muffler. (Fig E)
3. Using a 3/8” drive ratchet and 15mm deep socket, loosen the driver and passenger side clamps at the cat-back
connection point. (Fig. F)
4. Remove the grounding wire clamp from the passenger rear muffler hanger. (Fig. G) Then, using a 3/8” ratchet
and 13mm socket, long extension, unbolt the front and rear hanger grommet assemblies form the vehicle
chassis. (Fig. H) The remaining portion of the stock exhaust can now be removed by sliding the system
rearward to clear the overlapping pipe connection and the cat-back connection point; then lower the remaining
portion of the stock exhaust system. (Fig. I)
5. Using grommet pullers or a similar device, remove the front and rear hanger grommet assemblies from the rear
driver and passenger side mufflers. Make note of the hanger grommet assemblies’ orientation as they will be
installed in the same position on the Corsa Performance exhaust system. (Fig. J)
NOTE: The use of a soap and water solution may aid in the removal of hanger grommets.
REMOVAL PICTURES ON NEXT PAGE