Owners manual

INS5341
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
2
3/7/2016
[e-mail] l corsaperformance.com
4.0” Dia. Pro-Series Tip Kit
15+ Charger 5.7L Pursuit Rear Valance
PN 14977 & 14977BLK
Please take time to read and understand these installation instructions.
CORSA recommends that the installation of this system be performed by a qualified service center or professional
installer who has the necessary equipment, tools and experienced personnel. However, if you decide to perform this
install the use of an additional person may be required.
CAUTION: Never work on a hot exhaust system. Allow time for the vehicle to cool. Always wear eye protection
when working under a vehicle.
Recommended Tools:
 3/8” Drive 15mm Deep Socket
 3/8” Ratchet
 Torque Wrench
Please confirm that all parts are present according to the bill of materials before beginning the installation.
If something is missing call Tech Support at 440.891.099 or Toll Free: 1.800.486.0999
WARNING! PLEASE READ! • WARNING! PLEASE READ! • WARNING! PLEASE READ!
Apply the anti-seize lubricant (supplied) to the threads
ONLY of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly
calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively
seal the joint. It may also cause the joint to separate,
thereby causing damage to your exhaust system and to
your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
Bill of Materials
 13BE3008 (2)
 16CV7006 (2)