Owners manual

INS5036
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
5
07/27/2018
[e-mail] l www.corsaperformance.com
2005-2008 CHEVROLET CORVETTE C6
Axle-Back Exhaust
Part #: 14169, 14469, 21009, 21010
WARNING! DO NOT SKIP THIS STEP!
Apply the anti-seize lubricant (supplied) to the threads
ONLY of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly calibrated
Torque Wrench. Using an air impact gun will damage the
clamp and reduce its ability to effectively seal the joint. It
may also cause the joint to separate, thereby causing
damage to your exhaust system and to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
Remove all exhaust system components from the shipping
carton, including clamps. NOTE: There are two 2.5-inch
clamps supplied.
1. Locate the Driver side and Passenger side axle pipes
(See Fig. L & M).
2. Slide both Driver and Passenger axle pipes into position
from the rear (See Fig. N).
Continued on Next Page . . .