Owners manual

INS5036
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
3
07/27/2018
[e-mail] l www.corsaperformance.com
2005-2008 CHEVROLET CORVETTE C6
Axle-Back Exhaust
Part #: 14169, 14469, 21009, 21010
CAUTION: Never work on a hot exhaust system. Allow the vehicle to cool for at least an hour and a half. Always wear eye
protection when working under a vehicle. It is recommended to use cotton gloves in order to protect stainless steel
surfaces from permanent grease and oil stains.
Your C6 must be raised high enough to remove the one-piece stock muffler and over-axle pipe assemblies.
A vehicle hoist is strongly recommended for this task.
REMOVAL INSTRUCTIONS
FACTORY EXHAUST
1. Using a 15 mm socket or wrench, remove the
four front flange nuts (See Fig. A).
2. Using a 13 mm socket or wrench, remove the H-
Pipe hanger nuts (See Fig. B).
3. Using a 15 mm socket or wrench, loosen the
clamps connecting the H-Pipe to the Rear
Muffler Assembly (See Fig. C).
4. Slide the flanges off the bolts (See Fig. D).
5. Remove the H-Pipe assembly.
6. Using an 18 mm socket and a 15 mm open end
wrench, remove the rear stabilizer bar mounting
nuts (See Fig. E). Both sides.
7. Use an 18 mm socket to remove the upper
stabilizer bar mounting bolts (See Fig. F).
8. Swing the stabilizer bar down, away from the
rear cradle.
Continued on Next Page . . .