Owners manual

ManualsBrandsCorsa Performance ManualsAutomotive14959BLK Xtreme Axle-Back Exhaust System Fits 09-13 Corvette

140 Blaze Industrial Pkwy, Berea, OH 44017 l Toll Free: 1.800.486.0999 l Fax: 440.891.1868 l www.corsaperformance.com

05-08 CHEVROLET

CORVETTE C6

IMPORTANT! WARRANTY AND

INSTALLATION INSTRUCTIONS

Please Forward All Information to Consumer

Be sure to review the enclosed instructions prior to beginning the installation process. If you have any

questions about the enclosed parts or instructions, or if you encounter a problem during installation:

CALL TECHNICAL SUPPORT: 440.891.0999 or 800.486.0999

COLOR INSTRUCTIONS ARE AVAILABLE BY PART NUMBER ON: CORSAPERFORMANCE.COM

NEVER work on a hot exhaust system.

Allow time for the vehicle to cool.

Always wear eye protection

hen working under a vehicle.

INSTALL DIFFICULTY

RECOMMENDED TOOLS & SUPPLIES

 13 mm Socket

 Torque Wrench

 18 mm Socket

 15 mm Socket

 15 mm Open End Wrench (20-100 ft.-lb.)

 Drive Extensions for Ratchet (min of 17 IN)

ADDITIONAL TOOLS FOR AUTO TRANSMISSION CARS ONLY:

 Large Flat Head Screwdriver

 Rubber Mallet

 Needle Nose Pliers

TO ACTIVATE YOUR WARRANTY GO TO:

CORSAPERFORMANCE.COM/WARRANTY

Summary of content (6 pages)

PAGE 1
05-08 CHEVROLET CORVETTE C6 IMPORTANT! WARRANTY AND INSTALLATION INSTRUCTIONS Please Forward All Information to Consumer Be sure to review the enclosed instructions prior to beginning the installation process. If you have any questions about the enclosed parts or instructions, or if you encounter a problem during installation: CALL TECHNICAL SUPPORT: 440.891.0999 or 800.486.0999 TO ACTIVATE YOUR WARRANTY GO TO: CORSAPERFORMANCE.
PAGE 2
005-2008 CHEVROLET CORVETTE C6 Axle-Back Exhaust Part #: 14169, 14469, 21009, 21010 Please take time to read and understand these installation instructions. CORSA recommends that the installation of this system be performed by a qualified service center or professional installer who has the necessary equipment, tools, and experienced personnel. However, if you decide to perform this installation yourself, the use of an additional person may be required. WARNING: Never work on a hot exhaust system.
PAGE 3
2005-2008 CHEVROLET CORVETTE C6 Axle-Back Exhaust Part #: 14169, 14469, 21009, 21010 CAUTION: Never work on a hot exhaust system. Allow the vehicle to cool for at least an hour and a half. Always wear eye protection when working under a vehicle. It is recommended to use cotton gloves in order to protect stainless steel surfaces from permanent grease and oil stains. Your C6 must be raised high enough to remove the one-piece stock muffler and over-axle pipe assemblies.
PAGE 4
2005-2008 CHEVROLET CORVETTE C6 Axle-Back Exhaust Part #: 14169, 14469, 21009, 21010 REMOVAL INSTRUCTIONS FACTORY EXHAUST 9. 2005 Automatic Transmission ONLY: On the Passenger side, cut tailpipe 3-4” after H-Pipe joint (See Fig. G). 10. Slide the rear muffler hangers out of the rubber isolators, using soapy water to aid in removal if needed. (See Fig. H). 11. Carefully slide the Driver side muffler out of the vehicle. 12. Carefully slide the Passenger side muffler out of the vehicle (See Fig. I). 13.
PAGE 5
2005-2008 CHEVROLET CORVETTE C6 Axle-Back Exhaust Part #: 14169, 14469, 21009, 21010 WARNING! DO NOT SKIP THIS STEP! Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure to follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be tightened using a properly calibrated Torque Wrench.
PAGE 6
2005-2008 CHEVROLET CORVETTE C6 Axle-Back Exhaust Part #: 14169, 14469, 21009, 21010 INSTALLATION INSTRUCTIONS CORSA EXHAUST 3. Insert the axle pipes into the H-Pipe outlets and snug fit the clamps (See Fig. O). Note: If using the factory H-Pipe, axle pipe will not bottomout in the expansion. This is as designed. 4. Before installing the rear mufflers, cap both vacuum lines in the rear bumper with the supplied rubber caps.