Owners manual

02/23/2017
INS5317
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
6
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Axle Back Exhaust System
Dual Rear Exit w/ Twin 4.0” Pro-Series Tips or
Dual Rear Exit w/ Single 4.5” Pro-Series Tips
2016+ Chevrolet Camaro SS 6.2L V8
PN 14784(BLK), 14785(BLK), 14786(BLK), 14787(BLK)
Installation of CORSA Exhaust System:
NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure to
follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be
tightened using a properly calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively seal the joint. It may also
cause the joint to separate, thereby causing damage to your exhaust system and
to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the
notch in the pipe. (See Fig. CLAMP)
1. Remove all exhaust system components from the shipping boxes, including clamps and hardware.
NOTE: If your vehicle is NOT equipped with the factory optional NPP quad exit exhaust, skip step 2 and
proceed to step 3.
2. Wrap both of the plug connections for the two rear NPP (non-AFM) valves with electrical tape to protect them
from contamination, then tuck them up into the chassis. They will no longer be needed. Secure with a zip tie or
equivalent. (Fig. K & L)
3. Locate two 2.75” clamps and both rear mufflers. Install each of the clamps on the muffler inlet pipes so that the
bolt is vertical with the nut towards the ground and the bolt is towards the inside of the vehicle. (Fig. M) Slide
one of the muffler inlet pipes over the stock exhaust pipe, then slide the muffler hanger into the front hanger
grommet located just behind the rear suspension on the vehicle. (Fig. N & O) Snugly tighten the clamp
connecting the muffler inlet pipe onto the stock exhaust pipe using the ratchet and 15mm deep socket, leaving
it loose enough for further adjustment. (Fig. P) Repeat for the opposite side rear muffler.
NOTE: The use of a soap and water solution may aid in the installation of hanger grommets.
4. Locate both hanger grommet assemblies removed during step #4 of the stock exhaust removal process, along
with the two tip assemblies, two 2.75” clamps, and the four 15mm nuts removed during step #3 of the stock
exhaust removal process. Install the hanger grommet assemblies onto both tip assemblies in the same position
as previously installed on the stock exhaust, and install each of the clamps on the tip inlet pipes so that the bolt
is vertical with the nut towards the ground and the bolt is towards the front of the vehicle. (Fig. Q)
NOTE: The use of a soap and water solution may aid in the installation of hanger grommets.
INSTALLATION INSTRUCTIONS CONTINUED ON NEXT PAGE