Owners manual

08/18/2017
INS5284
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
3
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Valve Back Exhaust System
2014+ C7 Corvette (2017 GrandSport Auto)
PN’s 14762, 14763, 14764, 14765
Polished & Black Quad 4.5” Pro or Poly Tips
Tip Section Bill of Materials
1. Tip Assembly:
14062/14062BLK (Quad 4.5” Pro Series Tip Asm. – Used on 14762/14764)
14063/14063BLK (Polygon Tip Asm. Used on 14763/14765)
2. 16CN7017 – Tip Hardware Kit
Factory Exhaust System Removal:
NOTE: This process involves the removal of the lower rear fascia, followed by the removal of the stock axle
back components. The forward section of the stock exhaust (from the axle pipe inlet to just after the AFM
valve) will be cut off and reused when installing the CORSA system.
1. Remove the two bolts above the tip location using a 10mm socket and 3/8” ratchet. (Fig. A)
2. Remove the ten bolts that secure the bottom corners of the lower fascia (5 per side) using a 7mm socket and
1/4” ratchet. (Fig. B & C)
3. Remove the two lower mesh inserts on each side of the lower fascia. Each one is snapped in place using six tabs,
which can be pushed out from the inside of the fascia. (Fig. D & E)
4. Unsnap each lower rear corner of the rear fascia by pushing the end of the tab inwards while pushing the rear
fascia up and then backwards. (Fig. F & G)
5. Unscrew and remove the license plate to enable access to the two upper center mounting bolts for the rear
fascia. (Fig. H)
REMOVAL CONTINUES ON NEXT PAGE; REMOVAL PICTURES ON PAGES 5-7